General Specifications
| Dimensions (TZ5) | Milimeters | Feet | Inches |
| Length | 6,058 | 19′ | 11″ |
| Width | 2,438 | 8′ | 0″ |
| Height | 2,591 | 8′ | 6″ |
| Capacity | Liters | Imperial Gallons | US Gallons |
| 24,000 | 5,281 | 6,340 | |
| 25,000 | 5,500 | 6,605 | |
| 26,000 | 5,720 | 6,870 |
Shell Material Stainless steel, A 240 316 (316533).
Frame Material Structural steel to BS 4360 Grade 50A, B & C.
Shell Thickness Shell and ends 4.47 mm and 4.70 mm respectively.
Working Pressure 4 Bar (58.0 psi)
Test Pressure 6 Bar (87.0 psi)
External Vacuum Pressure 0.41 Bar (5.9 psi)
Design Temperature -40/140C (248F)
Design Code ASME VIII Division 1
External Finish Framework shot blasted to SA 2.5 and painted using a vinyl co-polymer resin.
Internal Finish Better than 180 grit with the total interior acid cleaned, and certified for the carriage of foodstuff.
| Weights | Kgs. | Lbs. |
| Max Gross | 36,000 | 79,365 |
| Tare | 3,550 | 7,826 |
| Max Payload | 32,450 | 71,539 |
Fittings
Manlid Fort Vale 500 mm, low profile fully hinged with 8-point fixing complete with stainless steel swing bolts with naval brass hand-nuts.
Air Line1.5″ BSP stainless steel butterfly valve fitted with an integral flame arrester. Terminates in a 1.5″ BSP dustcap with a retaining wire. Facility for pressure gauge connection exists.
Bottom Outlet 3″ 45 deg combination bottom outlet. 3″ foot valve with clamped 3″ butterfly valve with 3″ BSP threaded connector with stainless steel cap and retaining chain. Remote control connected to internal valve-kick cable type. Fusible link fitted when applicable.
Top 3″ nominal bore with removable siphon tube, 3″ butterfly valve Outlet and 3″ Table ‘D’ blank flange. Safety Relief One 3″ BSP “Super Maxi” high flow pressure relief valves set
Valvesat 4.4 bar (63.8 psi). Provision for second SRV
TopAll top fittings are housed in two stainless steel spill boxes
Compartmentscomplete with stainless steel drain tubes.
Insulation 50 mm thick Isowool. Complete outer cladding of 0.8mm thick aluminum marine grade 5754 mill finish with swaged joints.
Steam HeatingComprising of 10 longitudinal stainless steel channels (2.5 x 2.5 x 100mm).
SystemEffective heating area of 10 sq. meters (107sq. ft.) with 6 BAR (87 PSI) MAWP. Outlet: 3/4″ BSP connection with plastic cap and retaining wire. Inlet: 1″ BSP connection with plastic cap and retaining wire.
Thermometer One Contact type analog from -40ºC to 160ºC with dual ºF readings Located at the rear end.
ApprovalsBV, ADR/RID, T-11 IMDG, IM101 (US) DOT, (UK) DOT, IMO Type 1, UIC, TIR, CSC, AAR 600, TC Impact Approved. FRA, DIR (Australia).
